Duroguard Etch Primer
Etch primer for steel, aluminium, aluminium alloys and zinc-based alloys, designed for thin uniform films and rapid recoating.

Etch primer for steel, aluminium, aluminium alloys and zinc-based alloys, designed for thin uniform films and rapid recoating.
Explore the product story, application guidance and technical information in a clear, responsive format.
Duroguard Etch Primer can be applied by spray or brush and, under normal conditions, is touch dry in 10–15 minutes. It can be recoated after one hour with cellulose, synthetic or oil-based materials. Product information specifies an equal volume of Etching Solution and recommends allowing the mixed material to stand for about 30 minutes before use.
Product information specifies equal-volume Etching Solution, about 30 minutes standing time after mixing, one thin uniform coat and recoat after one hour.
Follow the product-specific application guidance below and use the method shown for the product.
Add an equal volume of Etching Solution to Duroguard Etch Primer.
Shake the Etching Solution before addition.
After addition, allow the mixture to stand for about 30 minutes for best results.
Thoroughly clean the surface by removing rust, grease and dirt; abrasion is not necessary as specified in the product directions.
Apply one thin, uniform coat by spray or brush; do not attempt to obtain obliteration with a heavy coat.
Allow one hour before recoating with cellulose, synthetic or oil-based materials.
Actual coverage may vary depending on application method, surface condition and surface roughness.
Apply only a thin uniform film; heavy coats can reduce adhesion of the complete paint system.
The flash point is below 73°F as specified in the product directions.
Galaxy Colors products can be matched to your colour requirement. Share your requirement with our team and we can take it forward.
Share a few details and we will prepare a clear enquiry email for our Customer Care team.